![]() This will extend the hole into the drywall or backer board with minimal damage. Now you can speed the drill up while backing off the pressure. You’ll feel a change in resistance when the bit gets through the tile.Steady pressure and a medium speed will drill the hole without overheating and damaging the drill bit.Once the hole is started, you can increase the drill speed, but don’t run it at full speed.Go slowly, particularly at first, to make sure the hole ends up where you want it.The tape not only makes it easier to mark the wall but also helps to keep the drill bit from skidding when starting the hole.Try to locate the hardware close to the center of the tile – the edges crack more easily.For accessories such as towel bars with two mounting brackets, use a level to make sure both sets of holes align.It’s easier to accurately mark the hole location on tape than on tile. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |